LS8 Rudder Push/Pull
Push pull rudder for the LS8, would have been nice if the rear was a little wider to hide the linkage system, but hey chinese, what...
May 29, 2018
$1.50 Voltage Monitor
Found these little rippers on Aliexpress for $1.50ea. Minimal draw if constantly connected, but i’ll just have it disabled and can check the volts between flight.
May 27, 2018
433mhz tx FPV
This is so cool, have started looking into FPV, have ordered a little bit of gear to get started, but this tx will be the start...
May 25, 2018
LS8 Progress
Working on the rudder, using the supplied wire run on the connectors, work nicely but its a long run. Elevator sorted as well.
May 22, 2018
Radian First Flight
What a gentle little plane, just floats. Had 5-6 climb outs with two batteries, even managed to get a ripper thermal that i had to apply...
May 22, 2018
Radian XL2.6M
So, ever since I moved into my house in Toowoomba i’ve always wanted to toss a plane off the deck at the back of the house,...
May 4, 2018
Flying the Mace 2
OK Models Mace 2 Well, what a great little plane! I was suprised on how well it flew being a pre built from China. You always...
April 29, 2018
Aeronaut Triple Thermic
Well, have to love when the postman arrives, always bring me lovely toys. The Aeronaut Triple (thermic) version. Stay tuned for the build on this.
April 18, 2018
Wings 95%
Almost complete on the wings, just have to sand off the tips, pop a couple spar caps on and its ready to cover.
March 23, 2018
Graphite has arrived!
Yipee, its arrived, just added the RX and a clean up and ready to go. Now, just to have a day that is working for me……...
February 28, 2018
Comments